The objective of the project is to develop/improve practical, reliable and internationally recognized methods for assessing/pre-screening the long-term structural performance of engineered wood products used in residential and non-residential applications.
The objectives of this project are to provide research information suitable for implementing design procedures for diaphragms with thick sheathing in the Canadian Standard for Engineering Design in Wood (CAN/CSA O86.1) and to make the information available to other markets by publishing the results and recommended procedures in a journal article.
Wood design standards in Canada and the United States provide design values for floor and roof diaphragms with sheathing thickness ranging from 9.5 mm (3/8 in) up to 18.5 mm (3/4 in), that are supported by joists spaced less than 610 mm (24 in) on centre. This range of sheathing thicknesses is adequate for housing and small buildings, but for large non-residential structures, diaphragms with thicker sheathing and wider joist spacing may be more appropriate.
This paper includes the findings of a study aimed at providing research information suitable for implementing design values for diaphragms with thick sheathing in the North American wood design standards. Results from quasi-static monotonic tests on fifteen full-scale 7.3 m (24 ft) long by 2.4 m (8 ft) wide diaphragms framed with 38x191 mm or 38x235 mm (nominal 2x8 and 2x10, respectively) solid sawn lumber or laminated strand lumber and sheathed with plywood or oriented strand board are discussed.
A numerical model was developed using the finite element method. The basic properties of the sheathing, framing members and nailed connections were implemented in the model to replicate the structural behaviour of the diaphragms with thick panels. The numerical model was successfully validated against the experimental data. The shear resistance values for the diaphragms with thick panels tested in this study were calculated. The model may be used to interpolate between various diaphragm configurations and calculate shear resistance values for other configurations of diaphragms with thick sheathing.
In the long run, it is hoped that the use of thicker sheathing will enable the use of structural systems that are cost effective for wider joist or beam spacing than systems made with dimension lumber and traditional sheathing thickness. The experimental data and the model developed in this project will be used to develop proposals for implementation of wood floor and roof diaphragms with thick panels in the Canadian and United States wood design standards.
This report describes work to provide research information suitable for implementing design procedures for diaphragms with thick sheathing in the Canadian Standard for Engineering Design in Wood (CAN/CSA O86.1) and to make the information available to other markets by publishing the results and recommended procedures in a journal article.