Fibre-reinforced wood systems are light, strong, stiff composites that can efficiently replace larger wood members and can be relied on to provide consistent mechanical properties.
This report is an introduction to fibre-reinforced wood systems for members of the Canadian wood products industry. It provides the motivation for reinforcing wood with synthetic fibres, and surveys the choice of materials and their uses. Numerous examples of current applications are discussed to demonstrate the strong and weak points of various approaches and examine the durability and management of fibre-reinforced wood products, as well as to indicate opportunities that exist for the Canadian wood products industry.
This report is intended to be a useful reference for the Canadian wood products industry, and assist future developments in structural and non-structural applications of fibre-reinforced wood products.
The objectives of this project are to provide research information suitable for implementing design procedures for diaphragms with thick sheathing in the Canadian Standard for Engineering Design in Wood (CAN/CSA O86.1) and to make the information available to other markets by publishing the results and recommended procedures in a journal article.
Forintek has completed a two-year investigation of the NLGA SPS 6 Standard, Special Products Standard for Structural Face-Glued Lumber. The NLGA SPS 6 Standard prescribes product specifications and qualification and quality control requirements for structural products created by edge-gluing and/or fingerjoining lumber segments. Under the NLGA SPS 6 Standard, the design values assigned are based on the visual grade and the stress level achieved in qualification tests on the glue joints.
The project assessed the effect of the following three factors on strength of the NLGA SPS 6 product:
1. Tension proof-loading;
2. Relative location of fingerjoints in adjacent members when fingerjoined material is edge-glued;
3. Strength of the material used to make the NLGA SPS 6 product.
Results showed a positive effect of proof-loading, a minor effect of staggering of fingerjoints, and a highly significant effect of density of raw material on tensile stress of edge-glued specimens. It was confirmed that SPS6 products of greater commercial value can be obtained from lower grade lumber. However, visual grading of SPS 6 products proved to be more difficult than visual grading of lumber, because grade-determining wood characteristics were sometimes hidden in the bond line, and could not be properly identified.
The findings of this project can be used to fine tune the NLGA SPS 6 standard and the other NLGA fingerjoint and face-glued lumber product standards. The project will help the wood industry maximize the utilization of their raw material resource, resulting in increased profitability.